BEABA Mini therm Gebrauchsanweisung Seite 19

notE 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
a. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
ns
telephones and land mobile radios, amateur radio, AM and FM to fixed RF transmitters,
to
an electromagnetic site survey should be considered. If the measured field strength in the
es,
location in which the TH30F is used exceeds the applicable RF compliance level above,
on
the TH30F should be observed to verify normal operation. If abnormal performance is
on
observed, additional measures may be necessary, such as reorienting or relocating the
he
TH30F.
b. Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
The TH30F is intended for use in the electromagnetic environment specified below.
The customer or the user of the TH30F should assure that it is used in such an environment.
immunity test
wer Electrostatic
W) discharge
rer (EsD)
on iEc 61000-4-2
rs,
tic Electrical fast
he
transient/burst
ge
iEc 61000-4-4
of
surge
ng
iEc 61000-4-5
e Mini therm 90x120 v2.indd 19
iEc 60601 test level
6 kV contact
8 kV air
2 kV for power supply lines
1 kV for input/output lines
1 kV line(s) to line(s)
2 kV line(s) to earth
compliance Electromagnetic
level environment guidance
6 kV Floors should be wood,
contact concrete or ceramic tile.
8 kV air If floors are covered with
synthetic material, the
relative humidity should
be at least 30 %.
Not Mains power quality
applicable should be that of a typical
commercial or hospital
environment.
Not Mains power quality
applicable should be that of a typical
commercial or hospital
environment.
19
24/07/13 10