Rosenbauer RLS1000 Bedienungsanleitung Seite 20

Rosenbauer - RLS1000 Rosenbauer - RLS1000
Twin sockets - either socket can be used to charge and / or run the LED worklight. In
addition two light heads can be run simultaneously.
To use your RLS1000 make sure the plug from the light head is inserted into either of
the two sockets, the red locking ring on the plug should then be turned clockwise to
prevent the plug from being accidentally pulled out.
Your RLS1000 is designed to work in a harsh environment from low to high
temperatures. While high temperatures can have an adverse effect on LEDs this unit
has been equipped with a thermal monitoring and control system. A temperature
sensor monitors the LED light engine output and adjusts the power output accordingly,
protecting the LEDs whilst maintaining operation of the unit.

OPERATION - ADVANCED FEATURES


To use the unit simply press the on button and the light will come on to 100% power/
brightness and is ready for use. The additional buttons listed below allow other
features to be accessed.

Battery Status



 

 




 
 
 


(Button 1) = ON/OFF
   



 

 
(Button 2) = MODE - To select between worklight and flashing coloured
 
 
 
signal light mode.
 
 
 
 
 
(Button 3) = BRIGHTNESS - 100%, 150%, 8%, 25%, 50%, 75%.
 
   
 
 
 
 
 
 
 
 
 
 
 
 
  
 
 
 
 
 
 
 
20
 
 
 

 









fig 1 - Controls