Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FLUSH-MOUNTED PROGRAMMER FOR ROLLER BLINDS
ASSEMBLY
NOTE: The installation of this switch must always be carried out by an authorized installer.
Flush-mounted DIN 49073 55 mm boxes will be used (minimum depth 40 mm)
Surface-mounted, consult your supply warehouse.
Easy to assemble it is recommended rigid wire H0 7V/1,5 mm
Connections according to schematic located on the rear cover of the appliance.
PROGRAMMING
With the blinds down, displace all the cradles inwards.
Put the bottom switch in the clock position "
Choose the period of time desired to raise the blinds. Draw the cradles outward until
hearing a small engagement sound.
SETTING THE TIME
Rotate the dial in the direction of the arrows until the current time is made to coincide
with the marker (protuberance on the front of the casing).
MANUAL CONTROL
3 positions:
- Automatic program: Bottom switch to position "
Cradles outward connection on terminal 2.
Cradles inward connection on terminal 1.
- Total power OFF: Independent of the program. The two switches in position "0"
- Manual program: the automatic program does not work. Bottom switch in
position "
Side switch in ▲ connection on terminal 2.
Side switch in ▼ connection on terminal 1.
WARNING: Never turn the dial with the blind in motion.
TECHNICAL SPECIFICATIONS:
Power supply:
Switching capacity:
Own consumption:
Maximum recommended load:
Type of dial:
Minimum switching time:
Temperature limit:
DIMENSIONS
00/09.2014
INDEX
PINS
1
2
".
81
ORBIS TECNOLOGÍA ELÉCTRICA, S.A.
Lérida, 61
Telf.:+ 34 91 5672277;
ROLLMATIC
DIAL
24
0
0
MANUAL
OVERRIDE
M
~
3
4
5
L
N
" and the side switch in position "0".
" and side switch to position "0".
230 V~ 50 Hz
10 (4) A, 250 V~
1,6 VA
approx. 2200 W
Daily (D): 48 pins
Weekly (S): 96 pins
Daily (D): 30 Minutes
Weekly (S): 1h 45 min.
60 ºC
E–28020 MADRID
Fax:+34 91 5714006
E-mail:
info@orbis.es
http://www.orbis.es
AND AWNINGS
MANUAL
OVERRIDE
2
be used.
31.5
17.5
A016.16.56998
Werbung
