auna 10008986 Bedienungsanleitung Seite 11

Repeat play
You can listen the desired tracks or folder repeatedly by this function.
Random play
You can listen all the tracks in a random order by this function
CD / MP3 disc programming
Up to 20 tacks can be programmed for disc play in any order. Before use, be sure to press the stop button.
1. Set in CD mode.
2. Press the Memory button (2), " MEMORY " & " P01 " will appear and flashing on LCD display (14).
3. Select a desired track by using the Skip up
4. Press the Memory button (3) to enter the track into the memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press " Play/Pause
disc in the order you have programmed.
7. Press " Stop
• Press " Stop " button (13) at CD stop mode to cancel all programmed memory until the " MEMORY
" indicator disappear on LCD display (14).
• For MP3 disc / file, press the " Folder up " button (9) to select the 1st track of next folder directly
and hence to speed up the song selection.
• The programming mode will automatically stop if no button is being pressed in a period of about
• 30 seconds after pressing the Memory button (3).
Remark:
MP3 track format requirement:
• Bit rate : 32 kbps~320kbps, sampling rate : 32kHz, 44.1kHz and 48 kHz decodable
• The performance of playing MP3 disc is various from the quality of recording disc and the method
of recording. Furthermore, the searching lead-time for MP3-CD is longer than normal CD due to
difference format.
PLAYBACK OF MP3 SONG VIA USB STORAGE MEDIA
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media with USB
connecting port.
1. Set the system at standby mode first or other function except USB mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into completely.
Connecting the USB upside down or backwards could damage the
audio system or the storage media (USB thumb driver). Check to be sure
the direction is correct before connection.
3. Turn on the unit again by On/Standby button (6) and set press Tuner/CD
button (4) to select CD mode. Press CD/USB exchange button (8) to change
to USB mode. The system will start reading the storage media automatically
after connecting, and LCD display (14) will show the total number of MP3 files
being detected.
4. Repeat the same playback procedure as playing CD/MP3 disc as above.
" button (13) to terminate program play.
/Skip down buttons (10).
" button (12) to play the
11