Husqvarna PP 455 E Bedienungsanweisung Seite 17

2 Set the feeding flow on the unit to max by turning the
control on the remote control clockwise.
3 Tension the wire by carefully turning the knob on the
pressure reduction block clockwise until the wire is
tensioned sufficiently. Make sure to always check that the
wire is seated correctly in all the wheels on the saw.
4 Start the wire drive by turning the control for motor rotation
on the remote control clockwise.
5 Carefully increase the motor speed by turning the control
for motor rotation. A suitable working pressure when
cutting usually lies between 100 and 130 bar, but varies
depending on how many wheel sets are used in the
magazine, how much wire is in use and the hardness of
the material to be cut.
6 As the material is cut away the working pressure drops,
which is shown on the display, and the magazine must
then be tensioned. Do this by turning the knob on the
pressure reduction block clockwise.
STARTING AND STOPPING
7 The output tension on the magazine is shown by an
indicator on the machine (shown in the min position).
When the magazine cylinder is fully tensioned, the
machine must be stopped and the wire must be wound
around a new wheel set. Then continue to cut as above.
Stopping
• Lower the speed on the wire and allow the motor to stop
completely.
• Turn off the electric motor by pressing the remote control's
green button.
• Disconnect the incomming cables from the hydraulic unit.
• Disconnect the hydraulic hoses and the water hose from
the saw unit.
• The other steps are done in the reverse order to
assembling.
IMPORTANT! Always clean all the equipment at the end of
the working day. Do not use a high pressure washer to
clean the machine.
– 17
English