Charging The Batteries; Test Before Use; Transmission From Baby Unit / Reception On Parental Unit - Swissvoice Babycom 143 Bedienungsanleitung

Charging the batteries

If the batteries are almost discharged, the power display on the parental
unit flashes red and an alarm signal (3 short beeps) is emitted every 3
seconds. You must charge the batteries within the next 5 minutes;
otherwise the device will automatically switch off.
Note:
- Non-rechargeable batteries must not be charged up.
- Remove discharged batteries as they can leak and damage the unit.
- No alarm signal is emitted on the baby unit when the batteries are
discharged!

Test before use

Transmission from baby unit / reception on parental unit

- Place the units in the rooms where you want them to operate.
- Switch the units on: Press and hold the Power key for approx. 2
seconds. An acknowledgement signal is emitted and the power dis-
play lights up (green = batteries charged).
- Use the channel switch to switch the two units (parental/baby unit) to
the same channel (Channel 1 or 2).
- Set the same CTCSS code for both units: Use a pointed object (e.g.
pencil) to activate the microswitch and set the CTCSS codes (CTCSS-
Code = system for creating user groups on the same frequency).
There are 4 CTCSS combinations available, see "Table of CTCSS
Codes".
Babycom 143
45