General Safety Regulations; Personal Safety - Holmatro SCV 10 U Betriebsanleitung

EN
/i
Note
Symbol: emphasizes important information for optimal product use.
This symbol is displayed in the user manual with all regulations related to product use or
maintenance.
Always adhere to these regulations and to the locally prevailing safety regulations, and proceed very
carefully.
Inform all people involved in the activities of the operation about these safety regulations.
2.2

General safety regulations

• Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
• Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
• Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Except for electrical
parts, rinse parts that have come into contact with corrosive acid or liquid with a lot of water. Consult
your Holmatro dealer for a resistance list.
• Prevent dirt in and on the couplers.
• Protect equipment against sparks during welding or grinding activities.
• Avoid an unhealthy posture while working. It can result in physical complaints.
• Follow the inspection and maintenance instructions.
• Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
• Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.3

Personal safety

Personnel that uses or assists in the use of the equipment must wear all personal means of protection
as prescribed in the standard work procedure. Negligent use of personal means of protection can result
in serious injury. During use wear at least the following personal means of protection:
• Helmet;
• Safety goggles or full face shield;
• Safety gloves;
• Safety clothing for the entire body;
• Safety shoes with good ankle support and toe protection.
2.4 Safety regulations with respect to the operation of the system
• The maximum air inlet pressure should be set to 8 bar or 118 psi using the pressure regulator.
• The body of this control device can get very cold when deflating lifting bags.
• Always use cribbing when lifting objects.
• Never place more than 2 lifting bags upon another.
• Always make sure the lifting bag system is properly connected before proceeding operating any
control device.
• Never change the settings of any safety device.
2.5 Safety regulations with respect to maintenance
• Wear personal means of protection when performing maintenance tasks.
• Never work in a way that could jeopardize safety.
• Make sure that the equipment cannot roll away or tip over. The control and drive must be switched
off and safeguarded against unexpected activation.
14 916.279.030_002 SCV/DCV 10 U