Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Forced Termination
If you cannot turn the product off using applications or the operating system, you
can execute forced termination as a last resort by pressing the power button (A2)
for approximately 4 seconds. Be careful; when forced termination is executed, all
unsaved data is lost and recovery of the operating system may be required.
Controlling the Speaker Volume
You can control the speaker volume through the operating system of the
computer.
Installing the Roll Paper
Follow the steps below to install the roll paper. See Illustration G.
1.
Press down the cover open lever to open the roll paper cover.
2.
Remove the used roll paper core if any, and insert the roll paper. The
illustration shows the correct direction of the paper.
3.
Pull out some paper, and close the roll paper cover.
4.
Tear off the paper.
Securing the Product
You can secure the product to the installation surface with optional affixing tape
(hook and loop fastener, four pairs, Model: DF-10), following the steps below. See
Illustration H.
1.
Turn over the product so that you can see its bottom.
2.
With two pieces of the affixing tape combined, peel off the backing paper of a
pair on one side, and paste it to one of the specified positions on the bottom of
the product.
3.
In the same way, paste other three pairs of tape in the specified positions.
4.
Peel off the backing paper of each pair on the other side of the affixing tape,
turn over the product back on its bottom, and place and secure it firmly to the
installation surface.
Cleaning
Cleaning the Product Case
Be sure to turn off the product, and wipe the dirt off the product case with a dry
cloth or a damp cloth.
CAUTION:
Never clean the product with alcohol, benzine, thinner, trichloroethylene,
or ketone solvents. Doing so may damage or break the parts made of
plastic and rubber.
TM-T70II-DT User's Manual 8
Werbung
Inhaltsverzeichnis
