ION Treble LP Schnellstartanleitung Seite 4

Setup
Items not listed under
Power
Mounting
1. Tape the position guide to the area of
your wall where you would like to place
the Treble LP. A level may help you
ensure that the guide is straight. The
position guide
representation of the two mounting
holes on the Treble LP.
2. After taping the position guide to the
wall, drill a hole using a 6 mm bit
where each mounting hole is displayed
on the guide.
Tip: We recommend drilling your
mounting screws into the wall studs,
which you can locate using a standard
stud finder.
3. Remove the position guide from the
wall.
4. Insert the wall anchors into the drill holes.
5. Use a screwdriver to insert the included screws into the wall anchors.
6. Mount the Treble LP by placing the device's mounting holes over the screws fastened to the
wall.
4
Introduction Box Contents
Bluetooth Headphones
or
Bluetooth Speakers
provides a
are sold separately.
Tablet, MP3
Player, etc.
Mounting Holes