Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before First Use: Carefully unpack your appliance and remove all accessories. Wash them in warm, soapy water
then rinse and dry with a dry towel. Carefully wipe the exterior of the base if necessary. WARNING: Do not immerse
the appliance base in water or any other liquids.
Note: The first time this appliance is used there may be a small amount of smoke and odour. This is normal and is
due to the protective coating placed on the motor at manufacture to protect it during shipping.
•
Attach the Feed Chute to the Appliance Base. This is done by holding the Feed Chute at a 45 degree angle to
the right, inserting it in to the socket on the Appliance Base, then rotating it 45 degrees back to the left so that
it is locked in to place in the upright position.
•
Select a cone suitable for the slicing or grating task you require and fit it onto the star shaped drive mechanism
at the back of the Feed Chute. Rotate it slightly clockwise to hold it in place.
•
Cut the ingredients into pieces that will fit into the Feed Chute and place a suitable container under the outlet.
•
Connect the appliance to a suitable 220 -240V ~ 50Hz power outlet socket
•
Press the ON/OFF button once or twice to ensure that the Cone has locked into place and turns freely.
•
Make sure that the Pusher has been removed from the Feed Chute, and then insert the pre-cut food through
the top of the Feed Chute.
•
Press and hold down the ON/OFF button to activate the motor then slowly push the food down with the
pusher. Do not exert too much pressure on the pusher, as this could affect the quality of the end result and
could even cause damage to the appliance.
•
Turn off by releasing the ON/OFF button.
•
To remove the cone unlock the Feed Chute by rotating it 45 degrees to the right then lock it back into place by
rotating 45 degrees back to the left. The Cone can now be easily removed.
Remember to unplug the unit from the power outlet when it is not in use, changing parts or is left unatten-
ded. Always clean the product immediately after each use. Disassembly is reversal of assembly instructions.
•
Important: This appliance is designed for short term operation only. Do not run continuously for more than
2 minutes. After 2 minutes stop and rest for 1 minute to allow the appliance to cool.
•
Tip: For best results use firm ingredients. If the ingredients are too soft the will clump together and accumu-
late in and around the cone. If the ingredients are too hard the appliance and cones may become damaged.
Gerätenutzung
8
Werbung
Inhaltsverzeichnis
