Inhaltsverzeichnis - ASROCK A780FullHD Schnellinstallation

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 10)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (PORT0):
see p.2, No. 17)
SATAII_5
(SATAII_2 (PORT1):
(PORT4)
see p.2, No. 16)
(SATAII_3 (PORT2):
SATAII_3
see p.2, No. 14)
(PORT2)
(SATAII_4 (PORT3):
see p.2, No. 15)
SATAII_1
(SATAII_5 (PORT4):
(PORT0)
see p.2, No. 11)
(SATAII_6 (PORT5):
see p.2, No. 13)
Serial ATA (SATA)
Data Cable
(Optional)
ASRock
80-conductor ATA 66/100/133 cable
These six Serial ATAII (SATAII)
connectors support SATAII
or SATA hard disk for internal
SATAII_6
storage devices. The current
(PORT5)
SATAII interface allows up to
3.0 Gb/s data transfer rate.
SATAII_4
(PORT3)
SATAII_2
(PORT1)
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
A780FullHD Motherboard
the red-striped side to
Pin1
connect the black end
to the IDE devices
2 3 2 3 2 3
2 3 2 3