Sleep Mode; Operating Modes - Velleman PAMSB10 Bedienungsanleitung

The iReminder enters stand-by mode after about 30 seconds. The green LED
blinks every 10 seconds to indicate stand-by mode.
2. To exit stand-by mode, go to the HiProx Multi app and tap Help >
AirplaneMode > RECONNECT to reconnect to all the paired iReminder devices
and exit the app.

13.2 Sleep Mode

To enter sleep mode, proceed as follows:
1. On the iReminder, press and hold the FindMe button [2] during ± 3 seconds.
The device beeps once and the status LED blinks once (red) and then goes out,
indicating that the device is now in sleep mode.
If the device is still connected to the iPhone/iPad, the iPhone/iPad displays an
alert message and it beeps.
2. If necessary, stop the alarm sound on the iPhone/iPad by tapping the alert
message.
3. To exit sleep mode, press the FindMe button [2] once. The connection with the
iPhone/iPad is restored automatically.
Note: If the connection is not restored automatically, run the AirplaneMode
disconnect/reconnect steps.
13.3 Remove a Device Pairing Permanently
To permanently stop using a device with your iPhone/iPad, proceed as follows:
1. In the MainView list of available devices, select the device and tap the
button to enter the SetView screen. Tap the Remove button and tap YES to
confirm (fig. K). Tap OK to confirm (fig. L).
2. Go to the general Settings menu of your iPhone/iPad and select Bluetooth.
The list of paired Bluetooth devices appears. Tap the device you want to
remove and choose "Forget this Device" (fig. M).
Note: You may have to shut down and restart your iPhone/iPad to remove the
pairing information completely.

13.4 Operating Modes

The table below shows an overview of the various operating modes:
Mode Green LED
Pairing mode blinks once
per second
Connected blinks every
mode 5 seconds
Sleep mode out
Stand-by blinks every
mode 10 seconds
14. Troubleshooting
You try to connect to a paired device but cannot find it
Cause: the existing pairing information is corrupt.
Solution: remove the existing pairing information from your iPhone/iPad and then
pair the device again.
1. In the HiProx Multi app, disconnect the device: tap Help > AirplaneMode >
YES.
V. 01 – 02/09/2013
PAMSB10
Description
The device can be paired with an iPhone/iPad.
The device is active. The alarm will go off if the
paired iPhone/iPad is out of range.
The device is not active. No alarms will go off.
The device is disconnected from the iPhone/iPad. No
alarms will go off.
9 ©Velleman nv