VONROC OT501DC Originalbetriebsanleitung Seite 6

EN
with a standardised test given in EN 60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned:
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. On/off switch
2. Speed adjustment wheel
3. Mounting point for accessories
4. Grip
5. Quick change lever
6. Work light
7. Battery (not included)
8. Battery unlock button
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first use.
Inserting the battery into the machine (Fig. C)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (7) into the base of the machine
as shown in Fig. C.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. C)
1. Push the battery unlock button (8).
2. Pull the battery out of the machine like shown
in Fig. C.
6
Removing and mounting accessories (fig. B)
Worn or damaged accessories must be
replaced immediately.
Only use sharp and undamaged accessories.
• Release the quick change lever (5) and slide the
accessory forward to remove from the holder.
• Slide the accessory in the holder and fasten the
quick change lever (5).
The sanding pad and the sanding paper must be
used for sanding applications.
4. OPERATION
Switching on and off (fig. A)
• To switch on the machine, slide the on/off
switch (1) to the front.
• To switch off the machine, slide the on/off
switch (1) to the rear.
Setting the speed (fig. A)
The speed adjustment wheel is used for setting the
speed. The speed adjustment wheel can be set to 6
positions. The ideal speed depends on the applica-
tion and on the material to be worked.
Do not set the speed during use.
• Turn the speed adjustment wheel (2) to the
required position.
Hints for optimum use
• Clamp the workpiece. Use a clamping device for
small workpieces.
• Draw a line to define the direction in which to
guide the accessory.
• Firmly hold the machine by the grip.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the accessory on the workpiece.
• Slowly move the machine along the pre-drawn
line, firmly pressing the accessory against the
workpiece.
• Do not apply too much pressure on the machine.
Let the machine do the work.
• Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.
WWW.VONROC.COM