ASROCK P55 Extreme4 Handbuch Seite 25

2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 36)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 14)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1: see p.2, No. 23)
SATAII_5
(SATAII_2: see p.2, No. 24)
(SATAII_3: see p.2, No. 19)
(SATAII_4: see p.2, No. 27)
SATAII_6
(SATAII_5: see p.2, No. 33)
(SATAII_6: see p.2, No. 30)
Serial ATA3 Connectors
(SATA3_1: see p.2, No. 14)
(SATA3_2: see p.2, No. 13)
(SATA3_3: see p.2, No. 11)
(SATA3_4: see p.2, No. 10)
ASRock P55 Extreme4 Motherboard
connect the black end
to the IDE devices
These six Serial ATAII (SATAII)
connectors support SATA data
SATAII_3 SATAII_1
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
SATAII_4 SATAII_2
data transfer rate.
These four Serial ATA3
SATA3_4
(SATA3) connectors support
SATA3_3 SATA data cables for internal
storage devices. The current
SATA3_2
SATA3 interface allows up to
SATA3_1
6.0 Gb/s data transfer rate.
the red-striped side to Pin1
2 5 2 5 2 5
2 5 2 5