SOLIS 8371 Bedienungsanleitung Seite 56

4 . S TA RT IN G TO U SE THE BLEN DER
Only now plug the power plug of the completely unwound power cord into a
●
suitable power outlet. The LCD screen lights up, indicating that the speed setting
is 1 by displaying a 1.
Vertically insert the blender into the blender jug. Only the blender shaft must be
●
placed in the liquid or food you wish to blend, not the motor unit!
Avoid tilting the blender.
●
GB
Use the + or − button to select a speed between 1 and 16. You can read the
●
current setting from the screen.
You can adjust the speed up or down with the + resp. − button, there are
16 speed settings to choose from. Each press of the button will increase resp.
reduce the speed by one step. If you press and hold the button, the steps are
quickly counted up or down. The current speed is displayed on the screen.
If the correct speed setting is displayed, push the ON/OFF button into the posi-
●
tion I and hold it there. The blender is only switched on while you keep the ON/
OFF button held down. As soon as you let go of it, the blender stops.
Start blending and shredding by making small movements up and down and
●
slightly turning the blender back and forth.
The operation time is counted up on the LCD screen in seconds and minutes.
●
If you want to change the speed while blending, release the ON/OFF button and
●
reset the speed with the + and − buttons. After that, push the ON/OFF button
back to the position I.
If you want to quit blending, let go of the ON/OFF button and wait for the
●
attachment to come to a complete standstill. Only then pull the blender out of
the mixture to prevent food splashing out of the blender jug.
Pull the power plug out of the power socket
●
Note: After 9 minutes and 59 seconds, the display switches back to 00 seconds
and the appliance switches off automatically. However, you should never use
the blender for more than 1 minute; if you wish to chop very hard foods,
do not use it for more than 10 seconds.
110
5 . REMO VIN G THE ATTAC HM ENTS FROM
TH E B LEN DER SHAFT
You have to remove the attachment at the end of the mixing process. This is
●
done exclusively with the included key (S) – never attempt to remove the attach-
ments by hand, you might be seriously injured!
Make sure that the power plug is not plugged into the power socket.
●
Hold the handle of the key and push the fork of the key under the attachment
●
and against its shaft. You can hear a faint "Click".
Lever the blade attachment up with the help of the key – the attachment dis-
●
engages from the foot of the blender shaft. Point the foot of the blender away
from you to prevent the attachment from being launched into your direction or
even your face.
Carefully hold the attachment in one hand and the key in the other hand. Turn
●
the key to the position "K" and lift the attachment off.
You can place the cleaned attachment and the key in the accessory box.
●
Be careful when touching the blades with your hand – they are extremely sharp.
●
"Click"
push
turn
pull
K
111
GB