Denon DN-500BD Benutzerhandbuch Seite 23

•
Output Control
o Output Volume: When set to Variable, you can use the Vol –/+ buttons on the remote
control to adjust the volume level of the audio outputs and 7.1 outputs. When set to
Fixed, the Vol –/+ buttons on the remote control will be disabled, and the volume will be set
to the Maximum Volume (see below).
o Maximum Volume: Select the highest possible volume level of the audio outputs and 7.1
outputs: -10dB, -6dB, 0dB, +6dB, or +10dB. Be careful—higher volume levels can cause
distortion ("clipping"), which can damage your amplifier or speakers. If the Output Volume
(see above) is set to Fixed, the audio outputs and 7.1 outputs will play audio at this
volume level.
Network Setup
•
Function
o BD-Live Network Access: Select the level of access to BD-Live content on the internet:
Permitted (you can access all content), Partial Permitted (you can access only certain
content), Prohibited (BD-Live content is blocked). DN-500BD must be connected to the
internet (via its LAN port) for this feature to work properly.
o BD-Live: These options let you manage where DN-500BD downloads files while accessing
BD-Live content, if any. Press OK to open a window to configure each option.
BUDA Setup: This window shows the amount of free space on the selected drive (see
below). Press OK to format the drive (this will erase all content on the drive).
Please select the BUDA mode: Select the drive you want to use to store downloaded
BD-Live files: External (a USB drive connected to DN-500BD's USB port) or On board
(DN-500BD's internal memory). Note that you will need a certain amount of free space
on the drive to download some content properly (see above).
Important: Your USB drive must not use an NTFS file system.
•
Setting
o Interface: Select how DN-500BD will access the internet: Ethernet (the LAN port must be
connected to your Ethernet connection) or Wireless (DN-500BD will connect to your
wireless router). When you change this setting, you will be asked if you want to continue,
which terminates your current connection. When you select Wireless, you must also select
how you want to connect to the network: Scan (display available networks), Manual (enter
the network service set identifier [SSID] manually), or Auto (use Wi-Fi Protected Setup
[WPS]).
If you select Auto, select how you will connect to the network: PBC (press the WPS/Reset
button on your router within 120 seconds of selecting Next) or PIN (enter the PIN shown on
the screen into the software control panel for your wireless router or access point).
o Information: This option opens a window that shows the following information about your
internet connection: Interface, Address Type, IP Address, Subnet Mask, Default
Gateway, DNS1, and DNS2. (If DHCP is set to Off, you can enter this information manually
with the remote control. See below.) Press Return to return to the previous menu.
o Connection Test: Select this option to check DN-500BD's connection to the internet.
24