Denon DN-500BD Benutzerhandbuch Seite 13

Additional Functions
To select a Repeat mode, press Repeat on the remote control, or press Shift and Skip Back (
DN-500BD. It will cycle through 3 modes:
• Off: Normal operation.
•
Repeat Track: The current track will repeat continuously. In this Repeat mode, pressing
will Skip Back/Forward (
• Repeat All: The current title will repeat continuously.
To select a playback mode, press Random on the remote control. It will cycle through 3 modes:
•
Shuffle: Tracks on the CD will play in a random order without repeating. When all tracks on the CD
have played, playback will stop (unless a Repeat mode is selected).
•
Random: Tracks on the CD will play in a random order. Playback will continue indefinitely. Also,
tracks will also be allowed to play more than once.
•
Off: Normal operation.
To loop a section of the track:
1. Set the desired starting point by pressing A-B on the remote control, or press Shift and Skip Forward
) on DN-500BD. A- will appear on the screen.
(
2. Set the desired ending point by pressing A-B on the remote control again, or press Shift and Skip
Forward ( ) on DN-500BD again. A-B will appear on the screen, and the loop will start and repeat
continuously.
3. To stop the loop, press A-B on the remote once more, or press Shift and Skip Forward (
500BD once more. A-B will disappear from the screen, and playback will continue normally.
To jump to a specific track of the disc:
1. Use the number buttons (0–9) on the remote control to select the number of the desired track.
2. To confirm your choice, press OK or wait a few seconds. The desired track will start playing.
To cancel, press Clear.
To jump to a specific track or time of the disc:
1. Press GoTo on the remote control. The Information panel will appear at the top of the screen. (To
cancel the operation before selecting a track or time, press GoTo again or wait until the blue square
cursor in the Information panel disappears, and then press Info.)
2. Use the left/right cursor buttons (
• Track: Press OK to "unlock" this field. Use the up/down cursor buttons (
buttons (0–9) to select the number of the desired track, and then press OK to jump to it.
• Time: Use the up/down cursor buttons (
elapsed time for the Track or Disc. After that, press OK to "unlock" these 3 fields. Use the
left/right cursor buttons (
up/down cursor buttons (
number. Press OK to jump to that time in the track or disc.
3. To jump to another location, repeat Steps 1–2.
To close the Information panel, press Info.
14
/ ) will skip to the beginning of the current chapter only.
) to select either of the available fields:
) to select whether these 3 fields show the
) to select each field: hours, minutes, and seconds. Use the
) or number buttons (0–9) to enter each as a 2-digit
) on
All
) on DN-
) or number
TRACK TRACK
DISC DISC