AWT E-Series Montage- Und Bedienungsanweisung Seite 3

Safety instructions
1. Read and follow the instructions.
2. The product must be connected to a socket that meets the ipx4 rating.
3. Installation of the power unit must be carried out by electrician or distributor.
4. All pump's must be grounded.
The copper core ground wire specification should not be less than 2.5mm².
5. It is not allowed to modify the product, this voids warranty.
6. It is strictly forbidden to use this product after drinking or taking drugs.
7. Minors must be under parental supervision.
8. Do not use the strong corrosive liquids, such as sulfuric acid, hydrochloric acid,
alkaline liquor to clean this product.
9. Please stay clear of the pump's, these are hot while in use.
10. Please make sure that there is sufficient water in the tub,
this must at least reach 30mm above the highest jet.
11. The water intake must be kept clear at all times.
12. Do not use water over 60°C, this could damage to the product.
13. The use of this product without GFCI/RCD is prohibited.
14. Store in a warm and dry place.
15. No suitable for outdoor use.
16. The extra hozes and pipes are'nt suitable for constant presured connections.
So these can't be used to connect the product to the house water system.
17. The water pressure should be between 2,5-5 bar.
18. The product can be connected using 1 1/2 inch reinforced hose.
Installation instructions
1. Determine where the product will be placed.
2. The product must be level, small adjustments can be made by turning the feet.
3. Connect the water inlet and drain, these must be installed by professionals.
Make sure there are no knots in the hoses, the drain flexible and is 38mm.
4. Connect the product to the powerline. Please watch the technical specs.
5. Check all connections to make sure that these are clean and dry.
6. Fill the pool with water and check for any leaks.
Maintenance instructions
1. Acrylic surface cleaning:
Daily cleaning can be done with flannel or sponge and water; if there is any scratch on the surface of the
product, please use 1500 water grind paper to lightly grind the scratch, then use toothpaste and flannel to
polish it; Please do not use corrosive liquids.
2. Chrome cleaning.
This can be cleaned with a flannel or sponge.
3. Water intake cleaning:
Unscrew the top of the intake, take out the net. Clean the net under running water.
Attention