Connection Cable - Zanussi ZGG96624XA Benutzerinformation

ground connection agrees with the standards
and regulations.
• Do not let the power cable to heat up to a
temperature higher than 90° C.
Make sure that you connect the blue
neutral cable to the terminal with a
letter "N" on it. Connect the brown (or
black) phase cable to the terminal
which has a letter "L". Keep the phase
cable connected at all times.

CONNECTION CABLE

To replace the connection cable use only the
special cable or its equivalent. The cable type is:
H05V2V2-FT90.
Make sure that the cable section is applicable to
the voltage and the working temperature. The
yellow / green earth wire must be approximately 2
cm longer than the brown (or black) phase wire.
ASSEMBLY
1.
2.
3.
min. 150 mm
min. 55 mm
30 mm
4.
5.
6.
7.
8.
min. 650 mm
830 mm
27