Installation; Before The Installation; Connection Cable - Zanussi ZES3921IBA Benutzerinformation

Installation

WARNING!
Refer to Safety chapters.

Before the installation

Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.

Connection cable

• The hob is supplied with a connection cable.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
Installation of more than one hob
min. 650 mm
If several 30 cm hobs are to be installed side by
side into the same cut out, an assembly kit
including a support side bracket and
supplementary seals is available at our
Authorised Service Centres. The relevant
installation instructions are supplied within the
kit package.
18
Assembly
Place the sealing gasket A all around the edge
490 mm
of the cut out.
270 mm
Fit the hob in the cut out and push it down until
comes in contact with the kitchen top surface.
then remove the excess sealing.
R 5mm
+1
490 mm
+1
270
min.
55mm
mm
A
www.zanussi.com