Installation; Before The Installation; Connection Cable - Zanussi ZEE6940FXA Benutzerinformation

Labels supplied with the accessories
bag
Stick the adhesive labels as indicated below:
A
MOD.
PROD.NO.
SER.NO
DATA
A. Stick it on Guarantee Card and send this
part (if applicable).
B. Stick it on Guarantee Card and keep this
part (if applicable).

Installation

WARNING!
Refer to Safety chapters.

Before the installation

Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.

Connection cable

• For a single phase or two phase connection
use the following (or higher) mains cable
type: H05V2V2-F T min 90°C.
18
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
C
MOD.
PROD.NO.
SER.NO.
0049
C. Stick it on instruction booklet.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
Building In
min. 100 mm
min. 55 mm
TYPE
IP20
min. 650 mm
30 mm
560 mm
www.zanussi.com