General Instructions - wehncke Evolution Aufbauanleitung

Cleaning
- Use the usual commercial means of care for polyester tents for the cleaning of the tent.
- Do not wash the tent in the washing machine.
- Do not have the tent cleaned by the dry-cleaner.
Packing and storing
- Pack the components of the tent in a dry and clean condition to avoid the creation of
mould. Allow the parts to dry thoroughly if they have become wet during use.
- Store the parts of the tent at a dry place. The fabric, the rods and zipper may be
attacked by mould or corrosion if stored in a wet condition.
The site
- Select a site that is as level as possible and free from depressions in the ground.
- Remove stones, rocks, branches of trees and other objects before you begin with the
erection of the tent. Sharp edges may not only damage the tent but they can also be
very annoying.
- Erect the tent in such a way that the entrance is out of the direction of the wind. Also
make, if possible, use of natural wind breaking effects.

General instructions

- Make the transport bag completely empty.
- Separate, if required, the outside tent and the inside tent.
- Connect all rods in the required way.
- Place the accessories, such as earth nails, tent pegs, tensioning cables, etc. in the pro-
per way around you.
Erection
1. Push the 2 long poles (E) through the channels at the grey part of outer tent. Push the
short pole (F) through the remaining channel of the outer tent (ill. 1).
2. To erect the tent, the poles are to be bent one after another and tensioned with the
tent. At each corner of the tent they are joined to a spike that is pushed into the pole
(ill. 2).
3. Hang the inner tent into outer tent by putting the toggles of the inner tent into the rings
of the outer tent (ill. 3).
ill. 1 ill. 2 ill. 3