Maintenance; Error Codes - tecsup BABY Bedienungsanleitung

BABY requires no maintenance.
The LED plastic screen (polycarbonate 2 mm thick) is almost
indestructible, but the state of the screen can interfere with the quality
of the light available. Clean the screen regularly, with a non abrasive
cloth. It would be wise to replace the screen when needed during the
life of the lamp. It is a very simple operation, where only a TORX 10
screwdriver is needed.
The screen must be replaced if it is cracked or broken.
Be sure to optimise the Lithium battery pack, by not leaving the product
stored with the batteries discharged.
We also advise you to not expose the product to very high
temperatures.
Avoid storing for a period of:
- 1 week at T° superior to +50°C
- 1 month at T° superior to +45°C
- 6 months at T° superior to +40°C
Remark: BABY reduces its power before indicating any kind of error.
Error Code
(every 2 seconds)
1 flashing red
2 flashing red
3 flashing red
TECSUP – BABY – Users manual - 80300106 G – P 24 / 41
BABY

7 / MAINTENANCE

8 / ERROR CODES

Signification
Temperature too high inside BABY, the light
power is blocked at 50%.
The LED circuit is too hot, light power is
blocked at 50%.
The LED dissipater is too hot, the light power
is at 25% (and can switch BABY off totally).