Five Positions; Position 100; Position; Position 15 - tecsup BABY Bedienungsanleitung

BABY

3 / FIVE POSITIONS

3.1 Position 100%

If the battery has more than 30% charge at the moment it is switched
on, the light will be on full power: 30w. If the battery has less than 30%
charge at the moment it is switched on, the power of the light will be
at 15w on startup.
When the battery is fully charged, the power of the light remains at
100% for 3 hrs 30, then drops to 50% in order to reach a total autonomy
of well over 5 hrs 30. However, the user can over-ride the drop in power
by pushing the « lighting » button and reselecting 100%.

3.2 Position 50%

With one push on the « lighting » button, the user can limit the lights
power to 50% which makes the lights autonomy climb to well
over 9 hrs.

3.3 Position 15%

With a second push of the « lighting » button, the user can drop the
power to 15%. This low consumption makes the lights autonomy climb
to over 24 hours. Note that even with this reduced light, you are still
able to see clearly enough to move around, to read, etc.

3.4 Position "Flashing Beacon"

After the third push of the « lighting » button, the lamp goes onto
« flashing beacon » mode. The LED lamp will then flash every two
seconds, this mode enables the user to signal his position clearly and
anywhere.
>>>Typical Uses : sea rescue, mountain rescue, forest fire fighting,
accidents etc.

3.5 Position "SOS"

After the fourth push of the Lighting button, the case goes into « SOS »
mode, the LED light will repeatedly flash « SOS » in Morse.
>>> Typical Uses : sea rescue, mountain rescue, forrest fire fighting,
accidents etc.
TECSUP – BABY – Users manual - 80300106 G – P 18 / 41