Nice Oview Installierungs-Und Gebrauchsanleitungen Und Hinweise Seite 4

1
PRODUCT DESCRIPTION AND USE
Oview is a device designed for the programming and control of Nice devices
equipped with "BusT4", used for the automation of gates, garage doors, road
barriers with mobile arms and similar applications.
Any other use is to be considered improper! The manufacturer declines
all liability for damage resulting from improper use of the product and
other than as specifi ed in this manual.
1.1 – Main operating characteristics of Oview
The Oview device dialogues with other devices via the BusT4 cable; therefore
it can only communicate with products fi tted with the BusT4 connector, i.e.
those in the "NiceOpera" system (for information on this system, refer to the
box alongside, entitled "What is Nice Opera?").
Oview is only activated when connected to a device, as it is powered directly
by the latter.
Oview can be used both as a system for programming devices and as a sys-
tem for automation control. Use of Oview is especially recommended in auto-
mation systems with an advanced technological content, as it enables:
– programming of a device or several devices connected on a network;
– control of one or more automations;
– diagnostics of a device or several devices connected on a network.
– storage(*) of settings and programming of devices (storage is useful for
example to enable rapid re-confi guration of devices in the event of a replace-
ment of a system component).
(*) Note – The storage operation is only available when using the optional soft-
ware available for use with Oview (see chapter 7).
Oview is suitable for use both by the installer and user. Just one Oview device
enables the installer to program and modify data, and perform maintenance on
all devices present in a system. On the other hand, the user can use Oview to
control one or more automations on a daily basis.
If required, the installer can also provide the user with the programming settings
of a number of parameters. This can be useful if the user needs to change the
values of these parameters while using the automation.
If the case of a network of several devices, use of Oview enables the installer to
3 – English
confi gure all devices in a system one at a time, thus reducing the complexity,
times and movements normally required for such operations.
Note – For more information on how to construct a Bus network and how to
confi gure and manage the network by means of Oview, refer to the manual
"NiceOpera System Book" available on the website www.niceforyou.com
1.2 – Accessories (optional)
Oview is supplied with a 2 m cable for direct connection to a device and a sup-
port for wall-mounting.
All the other accessories listed below are optional:
– Bluetooth ® module, supplied with the Software "Oview Software Suite";
®
– GSM module, supplied with the Software "Oview Software Suite".
What is "NiceOpera"
Nice Opera is a system comprising various devices normally used in systems
for the automation of gates, garage doors, and road barriers with mobile arms.
These devices are:
– transmitters in the series NiceOne;
– receivers in the series NiceOne;
– control units of gearmotors with "Bus T4" connection.
There are also other supplementary software and hardware devices in addi-
tion to the above:
– O-Box programming unit with dedicated software, for transmitters
and receivers;
– Oview programming unit, for control units and receivers;
– a Bluetooth ® module and dedicated software, for data communica-
tion between Oview and a Personal computer or Palmtop;
®
– a GSM module and dedicated software, for data communication via
Internet between Oview and a Personal computer or Palmtop.
®
The GSM module also enables the use of a smartphone and
standard mobile phone: these can be used to send a command
to an automation by means of a call or text message; also, the
smartphone, equipped with the Windows
tem enables use of the software "Oview software suite".
®
Mobile operating sys-