Velleman CARSFM2 Bedienungsanleitung Seite 5

remote control
SEARCH
SHUFFLE
A B
6. Installation and operation
Refer to §5 for display indications.
Power
• Start the cars' engine and plug the car plug [A] into the 12VDC car cigar
lighter socket. Starting the car with the transmitter plugged in might
blow the fuse.
• The transmitter starts automatically. If not, verify the condition of the fuse
inside the plug [A] (see §8).
Manually switch power on or off by pressing and holding the POWER button
for ±2s.
Note: when no audio signal is detected for 1 hour, power is switched off.
Set frequency
• Auto-search: Switch on the car radio and press the SEARCH button to
automatically get the best quality frequency.
After auto-search is completed, the transmitter waits a certain time to allow
the user to set the same frequency on the radio. To change this time-out,
press the MENU/REPEAT button briefly 6 times and use the
set it between 2 and 6seconds.
• Manual search: Switch on the car radio and search for a free frequency on
the FM-band. Set the same frequency on the transmitter by pressing the
MENU/REPEAT button once followed by the
MENU/REPEAT button again to store the setting.
• Set the same frequency on the car radio, either manual or via the RDS auto
synchronization function. This function enables automatic synchronization of
the radio frequency with the transmitters' frequency after the auto search
function.
23/12/2010
switch between SD and USB
start auto search function
Select shuffle - repeat current track – repeat current directory -
normal mode
move to previous or next folder
volume up or down
skip to previous or next track
play or pause
fast reverse or fast forward, speed x2, x5 or x10
move to previous or next frequency
jump to stored frequency
set a bookmark
set boundaries for repeat section
CARSFM2
or
5
or button to
button. Press the
©Velleman nv
Rev. 02