Solo 160 Gebrauchsanweisung Seite 19

For USA only
Emissions Control Warranty Statement
The Environmental Protection Agency and Solo are
pleased to explain the emission control system on your
small non-road power equipment engine. In the US
new small non- road engines must be designed, built,
and equipped to meet the Environmental Protection
Agency's standards. Solo must warrant the emission
control system on your small non- road engine for the
period of time listed below provided there has been no
abuse, neglect, or improper maintenance of your small
non-road engine.
Your emission control system includes parts such as
the carburetor, the ignition system, and the exhaust
system.
Where a warrantable condition exists, Solo will repair
your small non-road power equipment engine at no
cost to you including diagnosis, parts, and labor.
Manufacturers Warranty Coverage
Solo's small non-road power equipment engines are
warranted for a period of two years. If any emission
control related part on your engine is defective, the part
will be repaired or replaced by Solo.
Preface
Dear Customer,
Congratulations for choosing this SOLO quality
product.
Models 160 and 161 are very powerful
motorised hedge trimmer manufactured in Germany
with a newly developed high-performance engine.
These hedge trimmer offer a professional, easy to
maintain layout.
The proven technology used in the Nikasil-
coated cylinder 2 cycle engine guarantees high
performance and low fuel consumption.
The Primer-start system and the half throttle
setting integrated into the choke lever ensure
particularly good starting characteristics.
The safety equipment incorporates the latest
technology and meets all national and international
safety regulations.
Prior to operating the unit, please read the
owner's manual carefully, and most importantly,
observe all safety rules.
Observe the maintenance guidelines closely to
ensure the long service life of your equipment.
Your dealer will be glad to assist you with any
questions.
Most importantly: In order to achieve an
body – not even when the cutting blades are
stationary!
exceptionally high quality
cut, the cutting blades are
extremely sharp.
Never allow the
cutting blades to come
into contact with an
unprotected part of the
Symbols
The following symbols are used in this manual and on the
product:
Thoroughly read these operating
instructions before undertaking any
maintenance, installation and cleaning
steps
Wear ear defenders and a face shield
before starting the engine
Wear protective gloves when handling and
working with the equipment
Wear solid shoes, preferably safety shoes
with a good tread
Always handle this power tool with
particular care
Never smoke near the power tool or where
the equipment is refuelled!
Keep open flames away from the power
tool and the fuel can
- This equipment produces exhaust fumes
and
- fuel vapours are poisonous;
never start or refuel in enclosed spaces
Choke open
Warm start and operating setting
Choke closed
Cold start setting
Packaging
The packing materials used to protect the unit
against damage during transportation are cartons
made from pulp, which can be re-used or recycled.
CE Declaration of conformity
In accordance with EG Directives 98/37/EC, 2000/14/EC and
89/336/EEC (amended by 92/31/EEC), SOLO Kleinmotoren
GmbH, Stuttgarter Strasse 41, D-71069 Sindelfingen, being
solely responsible, states that the product referred to in
this declaration complies with the requirements of the
Machinery Directive.
Sound power level (2000/14/EG)
Guaranteed sound
Actual sound
Applied standards:
Conformity assessment procedures
This declaration of conformity loses its validity, if the
equipment is converted or modified without the
manufacturer's consent.
Sindelfingen, 1 January 2005
st
SOLO Kleinmotoren GmbH
160 161
104 104 dB(A)
103 103 dB(A)
EN 774
Appendix V
Wolfgang Emmerich
Executive Director
ENGLISH 1