Intended Use; Start-Up; Operating Instructions - Hydas 4652.5.01 Gebrauchsanweisung

movement of the bed
• Do not fold or wrap around the mattress
• If the mains cable is damaged it must be replaced by an authorized repair
centre to avoid a hazard
• Examine the appliance frequently. If there is any damage visible If the
supply cord is damaged, it must be replaced by the manufacturer or a
qualified person, to avoid a hazard.

3 | Intended use

The technical safety of this product is assured by its compliance to European
standards. The safety guidelines in the instruction book must be followed. It
is however not intended to treat medical conditions.
As an added safety measure against overheating it contanies a temerature
sensative sensor cable.
After 30 minutes pre-heating the desired temperature is reached, and will
be maintained for another 90 minutes unless the blanket gets switched off
before. The bed should be warm not hot. The hand is not as sensitive towards
heat as other body parts. The heat is difficult to determine when touching
with your hands, other than the heat pillow.
Important: If you feel unwell or suffer any kind of injury, you must
consult your doctor.

4 | Start-up

If this device is stored near freezing, allow it to acclimate to room tempera-
ture before use.
a
Place the unit's mains plug into wall outlet. The electric blanket
ready for use
b
The electric blanket is placed on the mattress and under the sheet
It is not designed for use with animals. Inappropriate use can damage
the surface of the blanket and the fixing of the heating wires. If dama-
ged, the blanket must not be used anymore. In this case please contact the
service hotline.

4.1 | Operating instructions

2
• The switch has four levels:
14
1
is