Herunterladen Inhalt Inhalt Diese Seite drucken

DEHAS EASYMATE 6 Bedienungsanleitung Seite 32

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

If the vent-to-Fill lever fails to close and the hissing continues, remove the
Portable from the Reservoir. The Portable will stop venting in a few minutes.
The Portable may require as much as 30 minutes to restore normal
operation.
10. Disengagement:
a. Disconnect the Portable System from the
Reservoir by pulling in an upright motion.
Always hold the device with at least one
hand when attempting to disconnect it.
(Figure 2)
NOTE: • It is common to hear a hissing
• It is common to have a few
DO NOT OVERFILL
Filling device longer than specified fill times can lead to OVERFILLING.
Overfilling does NOT provide any advantages and can cause problems
with the use of the device. Overfilling can result in a delay of 30
minutes before the Portable can be used. Releasing the vent-to-fill
lever will stop the filling process.
• If a liquid oxygen leak occurs at the fill connector when you disconnect the
Portable, reconnect and disconnect the Portable System to help dislodge
any ice or other obstruction. If the liquid leak persists, notify your oxygen
supplier. DO NOT insert any foreign objects into fill connector.
• If you notice a steady stream of liquid oxygen at the fill connector when
you disconnect the Portable System, stay away from the device and
immediately notify your oxygen supplier.
• DO NOT leave the portable liquid oxygen system unattended during the
filling operation.
• DO NOT direct flow of oxygen at any person, or flammable material.
NOTE:
CAUTION
sound
after
System has been filled. This is
the relief valve venting excess
pressure. Upon disengaging the
Portable
System
Reservoir it is common to see
condensation on or near the fill
connector.
small droplets of liquid oxygen
coming from the fill connector
when disengaging the Portable
from the reservoir.
CAUTION
WARNING
If the Reservoir and Portable System does not disconnect
easily, they may have become frozen. Simply allow a few
minutes for the frozen parts to warm and then disengage
the Portable when the ice has melted.
the
Portable
from
the
9
Figure 2

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Easymate 6+6

Inhaltsverzeichnis