Using The Appliance - Philips sonicare AirFloss Pro Bedienungsanleitung

ENGLISH
10
Note: The AirFloss Pro only supports AirFloss Pro nozzles. Do not attempt to
use non-AirFloss Pro nozzles on the AirFloss Pro handle.
2 Open the cover of the reservoir ('click') (Fig. 6).
3 Fill the reservoir with mouthwash or water (Fig. 7).
Tip: For the best result and a fresher experience, we advise you to use
mouthwash with your AirFloss Pro.
Note: Do not use mouthwash that contains isopropyl myristate or high
concentrations of essential oils, as it may damage the appliance.
4 Close the cover of the reservoir by pressing ('click') (Fig. 8).
5 Press the power on/off button to switch on the appliance. (Fig. 9)
The LEDs light up.
,
6 Press and hold the activation button until spray comes out of the
tip of the nozzle (Fig. 10).

Using the appliance

1 Make sure the AirFloss Pro is switched on. If it is off, press and
release the power on/off button to switch on the appliance. (Fig. 9)
You can change the modes to have the desired amounts of bursts
,
each time you press the activation button. For optimal results, use
the triple burst mode (the default setting).
To change modes, press the power on/off button to cycle through
,
the modes until you reach your desired mode. The LEDs show the
selected mode:
- Single burst: 1 LED (Fig. 11)
- Double burst: 2 LEDs (Fig. 12)
- Triple burst: 3 LEDs (Fig. 13)
Note: The AirFloss Pro remembers what mode was selected last and it is
ready for the next use. If your AirFloss Pro becomes fully drained of power,
it goes back to the triple burst default mode once it has been recharged.
2 Place the guidance tip between two teeth at your gum line. Slightly
close your lips over the nozzle when it is in place, to avoid
splashing (Fig. 14).
35_021_3363_1_DFU-Booklet_A6_v1.indd 10 23/12/16 15:35