FUST NOVAMATIC EKI1710RE Benutzerinformation Seite 12

Problem
A rectangular symbol is
shown instead of numbers on
the Temperature Display.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after press-
ing the FastFreeze,Shopping
or after changing the temper-
ature.
Possible cause
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The FastFreeze function is
switched on.
The Shopping function is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
Solution
Contact the nearest Author-
ized Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ized Service Centre.
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func-
tion".
Refer to "Shopping function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
12