FUST NOVAMATIC EKI1710RE Benutzerinformation Seite 13

13
Problem
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
Water flows on the floor.
Temperature cannot be set.
Temperature cannot be set.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
Possible cause
During the automatic defrost-
ing process, frost melts on
the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The FastFreeze or Shopping
function is switched on.
The FastFreeze function is
switched on.
The Shopping function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Solution
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze
function" or "Shopping func-
tion".
Switch off FastFreeze man-
ually, or wait until the function
resets automatically to set
the temperature. Refer to
"FastFreeze function"
Switch off Shopping manual-
ly, or wait until the function
resets automatically to set
the temperature. Refer to
"Shopping function".
Keep the OK button pressed
for approximately 10 sec-
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.