Maintenance And Storage - Lanaform Lily Betriebsanleitung

Fill the water tank with clear water at 40°C maximum. Check that the silicon ring is in place and close the cover by
turning clockwise. EN
Verify the cleanliness and watertightness and then gently put the water tank back on the base.
With dry hands, connect the plug and turn the appliance on. The main signal light comes on. The appliance begins to
operate. Adjust for desired intensity of mist by turning the mist control knob.
How to use aromatic oil
To nebulise aromatic oils indoors, only use the oil
container supplied with the equipment Add a few
drops of aromatic oil into the oil container , taking
care not to fill it excessively. Then place the oil
container under the lid of the nozzle.
WARNING:
DO NOT USE ANY AROMATIC OILS DIRECTLY INTO WATER TANK.IT COULD PERMANENTLY DAMAGE THE
EQUIPMENT.
ALTHOUGH THE SAFETY DEVICE STOPS THE OPERATION OF THE TRANSDUCER, AVOID LEAVING THE
APPLIANCE PLUGGED IN WHENEVER POSSIBLE.
DO NOT PLUG IN OR UNPLUG THE APPLIANCE WITH WET HANDS.

MAINTENANCE AND STORAGE:

If the water is hard, meaning that it contains too much calcium and magnesium, it may leave a white powder in the
appliance and cause foaming at the surface of the tank, on the transducer (metal disc producing the ultrasonic waves),
and on the inside walls of the water tank. Foam on the surface of the transducer will prevent the appliance from
operating properly.
We recommend:
• Using boiled, cooled water or distilled water for each utilization,
• Cleaning the tank every three days, cleaning the transducer every week,
• Changing the water in the tank often so that it stays fresh – don't leave it for more than two days,
• Cleaning the whole appliance and ascertaining that all the components are perfectly dry when it is not in use.
To clean the transducer
Place 2 to 5 drops of vinegar on the surface and leave it from 2 to 5 minutes.
Brush the foam from the surface with a soft brush. Do not use a hard tool or scratch the surface.
Rinse the transducer with clear water.
Do not use soap or other alkaline substances to clean the transducer.
To clean the tank:
Clean the water tank with a soft cloth and vinegar if there is foam OR calcium deposits in it.
If the foam covers the safety switch, put a few drops of vinegar on it and clean it with the brush.
Rinse the tank with clear water.
LILY
5