Resetting To The Factory Default Settings; Further Information - Axis 213 Installationsanleitung

AXIS 213 - Installation Guide
9
AXIS Media Control (AMC)
AXIS Media Control (AMC) is an ActiveX component required for Microsoft Internet
Explorer, and is installed automatically on first use.
AMC must be installed for audio support and for viewing live images in Microsoft
Internet Explorer. If your working environment restricts additional software
components, you can configure your AXIS 213 to use a Java applet for updating the
images (applies to video images, not audio). See the online help files under Live View
Config > Layout > Default Viewer for Internet Explorer. Alternatively, use another
supported Web browser.
Once AMC is installed, the AMC viewer toolbar will display the audio controls and
additional video controls.
Accessing the AXIS 213 from the Internet
Once installed, your PTZ network camera is accessible on your local network (LAN).
To access the PTZ network camera from the Internet, network routers must be
configured to allow incoming traffic, which is usually done on a specific port. Please
refer to the documentation for your router for further instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup

Resetting to the factory default settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Reset button (on the underside of the camera) and reconnect
power.
3. Keep the button pressed for 15 seconds, and then release it.
4. Re-install the camera using one of the methods described in this document.

Further information

For further information, please see the AXIS 213 User's Manual, which is available on
the CD included in this package. Updated versions can be obtained from
www.axis.com