Inhaltsverzeichnis; Introduction To Use - Femi NG 120 XL Gebrauchsanleitungen Und Wartung

INDEX
1 INTRODUCTION TO USE.........................................7
2 INSTALLATION ........................................................9
3 ADJUSTING (Fig. 4-5-6-7-8) .....................................9
4 USE .........................................................................10
5 ACCESSORIES ......................................................11
6 MAINTENANCE ......................................................11
7 TROUBLESHOOTING ............................................12
1

INTRODUCTION TO USE

Before starting work with your sawing machine, carefully
read this instructions manual so that you are familiar with
the machine and its uses and where it should not be used.
Keep this manual in a safe place.
It is an integral part of the machine and should be used
for reference in operating the machine correctly and in the
proper safety conditions.
Use the machine only and exclusively for the uses specifi ed
below, as recommended in this manual. The machine should
not in any way be tampered with, or forced, or used for
unsuitable purposes.
1.1 SYMBOLS PLACED IN CORRESPONDANCE
WITH USAGE POINTS
Never underestimate the warnings "ATTENTION -
CAUTION" given in this manual.
In order to draw the user's attention and to preserve safety,
hazardous operation are preceded by symbols and notes
that point out the danger and explain how to behave to
avoid any risk.
These symbols and notes are divided in three categories,
identifi ed by the following words:
ATTENTION: dangerous-behaviours that could
cause serious injuries.
CAUTION: behaviours that could cause slight injuries
or damages to things.
NOTE: the notes preceded by this symbols are
technical and are aimed at making operations
easier.
1.2 SAFETY AND RULES
The machine was designed and built according to the
Community Directives in force: EC/2006/42 - EC/2006/95
- EC/2004/108.
The enclosed CE Declaration of conformity, togheter with
the CE mark on product, essentially comprise and are
an integral part of the machine : both guarantee product
conformity with the aforesaid safety Directives.
1.3 SAFETY PLATES/LABELS
The safety plates/labels and indicators present on the
machine, the location of which is shown in the Figure 12,
are as follows:
- Wear noise protection devices.
- Wear safety masks or goggles.
- Do not insert the hands in this area with the
tool operating. Danger of dragging/cutting.
Fig. 12
1.4 RECOMMENDED AND NOT RECOMMENDED
USAGE
This belt sawing machine was designed and constructed
according to the most advanced technologies and may be
used for all cutting requirements for metals commonly used
in industry and artisanship.
It can cut:
- COMMON STEELS (FE 37...)
- SPECIAL STEELS (C 40, 18NiCrMo5...)
- ALUMINIUM AND ITS ALLOYS
- BRASS
- BRONZE
- STEEL TUBING (FE 35, FE 52...)
- PROFILED SECTIONS IN SHEET METAL AND
ALUMINIUM
Matr. n. ...........
7