Accessories; Regular Maintenance - Femi NG 120 Gebrauchsanleitungen Und Wartung

4.4 CUTTING CAPACITY (Fig.10)
The table below specifies the cutting capacity at 0, 45 and
60 degrees which may be obtained in normal conditions of
use described in this manual and without placing any other
object between the jaws of the clamp.
SECTION ANGLE
0 gradi
45 gradi
60 gradi
4.5 CORRECT POSITIONING OF THE PIECE IN
THE CLAMP (Fig. 11)
The pieces to be cut should be fitted directly between the
jaws without adding other objects.
ATTENTION: Never hold the pieces to be cut in
your hand.
When the pieces to be cut are profiled sections, flat pieces
or special shapes, refer to the examples shown in the
figures.
If the thickness of the profiled section is to be very thin,
an outline should be fitted which copies the profile inside
the profiled section itself to stop it being crushed between
the jaws.
4.6
CUTTING
102
100 x 100
90 x 120
5
80
80 x 80
5.1
80 x 82
Your sawing machine is equipped with a bi-metal blade
measuring 1440x13x0.65 mm with variable toothing 8/12
50
teeth per inch, for use in the majority of cuts possible with
this machine.
43 x 43
For special requirements (see cutting table point 4.6), for
example, for cutting large solid sections or profiled sections
43 x 50
or corner pieces of small thickness, there are also blades
avail-able with 6, 14 or 18 teeth per inch.
MATERIAL:
EXTENSION :
HEIGHT:
THICKNESS:
TOOTHING:
6
6.1
The operations of ordinary maintenance, which may also
be performed by non-specialist personnel, are all described
in the previous sections and here below.
1. Before performing any maintenance operation,
disconnect the machine electric plug from the wall
outlet.
2. During maintenance operations, always wear personal
protection (safety goggles and gloves).
3. Remove the processing residues from the cutting
area and the blade guides whenever necessary.
You are advised to use a suction device or a brush.
4. If you do not intend to use the sawing machine for a
long time, clean it and put it in a dry place if possible.
In these cases it is advisable to slacken off the
blade so that it is not kept tight for no reason.
CUTTING TABLE

ACCESSORIES

CHOISE OF BLADE
M42 (acciaio per molle + acciaio HSS)
mm 1440
mm 13
mm 0,65
standard 8/12
MAINTENANCE

REGULAR MAINTENANCE

ATTENTION: Do not use jets of compressed air.
optional 6-14-18
11