Description Of The Front Panel; On/Off Switch - Nowsonic STAGE ROUTER PRO Bedienungsanleitung

Stage Router Pro
EN
User manual
USB
■
This high-speed USB 2.0 port can be used to connect a suitable external mass storage device to make images, music tracks or other documents
available on the network or to save them there.
LAN 1-3
■
These RJ45 ports can be used to connect the Stage Router Pro via standard CAT5 cables to a local desktop computer or other devices on a
Gigabit network.

Description of the front panel

The Nowsonic Stage Router Pro has the following controls and indicators on the front panel:

ON/OFF switch

■
Use this switch to turn the Nowsonic Stage Router Pro on or off. When the unit is turned on, the PWR LED lights up blue.
BNC ports 2.4 GHz ANT/5 GHz ANT
■
These BNC ports are used to connect the supplied radio antennas or the antennas from the optionally available Stage Antenna Set. It is recom-
mended that you connect two antennas per radio band. This will ensure an interference-free data transmission in the so called true diversity
mode.
NOTE: If you use additional radio microphone lines in parallel with the Stage Router Pro, you should configure the Stage Router Pro to transmit
only on the 5 GHz radio frequency (802.11n mode). Transmitting on the 2.4 GHz radio frequency (802.11g mode) can cause transmission prob-
lems (even in true diversity mode).
USB indicator, 1 – 4
■
These five LEDs are assigned to the USB port and the LAN 1 to 4 ports on the back panel. If a mass storage device is connected to the USB port,
the corresponding LED will light up blue. If one of the LAN ports is connected to another device, the corresponding LED will light up blue. If
data is being transferred, the respective LEDs will flash.
7
www.nowsonic.com