Usage Instructions; Description Of The Back Panel - Nowsonic STAGE ROUTER PRO Bedienungsanleitung

Stage Router Pro
EN
User manual
Do not place the Stage Router Pro on top of or below excessively heat-producing units such as power amplifiers.
•
When powering on the Stage Router Pro, please beware of low flying birds and UFOs. ☺
•

Usage instructions

■
To operate and establish a wireless connection with a computer, tablet PC or smartphone, position the Stage Router Pro as centrally as
•
possible.
Make sure to keep sufficient distance from potential sources of interference and ensure the Stage Router Pro is positioned in such a way that
•
the antennas are not concealed by any obstacles.

Description of the back panel

In addition to the professional PowerCon connector for connecting the supplied power cable, the Nowsonic Stage Router Pro also has the follow-
ing ports on the back panel (from left to right):
WAN
■
Use this pro-grade lockable RJ45 port to connect the Stage Router Pro via a standard CAT5 cable to a DSL cable modem or to your local Gigabit
network in order to connect to the Internet.
LAN 4
■
Use this pro-grade lockable RJ45 port to connect the Stage Router Pro via a standard CAT5 cable to the audio device (such as a digital mixer)
you would like to control.
NOTE: Next to the LAN 4 port, you will find the MAC address of the Stage Router Pro, which you will require to assign the device on the net-
work. On the label between the LAN 1–3 and PowerCon ports, you will also find the IP address as well as the user name and password needed
for configuring the Stage Router Pro. For additional information refer to Seite 10.
RST button
■
Use a small, sharp pencil or a bent paper clip to push the button in the opening labeled RST: If you press and hold the button for more than 5
seconds, the router will be reset to its default settings.
6
www.nowsonic.com