Absaar S-M Bedienungs Und Installationsanleitung Handbuch Seite 14

80%
20%
Battery test
Charging the battery
14
CHARGING CURRENT INDICATOR FOR STANDARD CHARGERS
LED Display:
Left LED lights up red:
The battery charger clamps have been connected with the correct polarity (+, -).
The charging process will start as soon as the charger is connected to the mains.
LED 1 will light up during the entire charging process.
Centre LED lights up yellow:
The charging process has started.
LED 2 will also light up during the entire charging process.
Right LED lights up green:
The battery is fully charged.
CHARGING CURRENT INDICATION FOR AUTOMATIC CHARGERS
BATTERY TEST
Important: The device must not be connected to the mains using the power cord when performing
the battery test.
1. Connect the red battery clamp (+) to the positive (+) battery pole.
2. Connect the black battery clamp (-) to the negative (-) battery pole.
3. Red LED – lights up immediately; the battery test lasts approx. 5 seconds.
4. Battery test result:
Green LED: Charging level OK – lit. The battery is sufficiently charged.
Red LED: Charging level low – lit. The battery is discharged. Recharging of the battery is
required!
5. Both LEDs (red and green) off: Battery clamps inverted!
If the battery test and charging are not possible, please:
Check the battery clamp polarity (+/-) on the battery poles. Connect the battery clamps with the
correct polarity. The battery test will be repeated automatically.
See steps 3 to 5.
CHARGING THE BATTERY
Once the battery clamps have been connected with the correct polarity (+, -) and you have con-
nected the power cord to the mains, the charging process starts.
Note:
The no-load voltage of a discharged 12V battery must be at least 3.8 V in order for the charging
process to start.
1. Connect the charger to the mains using the power cord.
2. The battery test is disabled while the battery is being charged.
3. The yellow and green LEDs will light up during the entire charging process.
During charging, the battery charging level is monitored by an electronic circuit.
GREEN LED (bottom): The charger is connected to the mains.
YELLOW LED: The battery is being charged.
GREEN LED (top): The battery is fully charged, the charger automatically toggles to a trickle
charge.
DIRECTIONS OF USE