Settings And Adjustments; Start Menu; Operations Menu - Husqvarna PP 480 HF Bedienungsanweisung

Start menu

The start menu is shown each time the power to the hydraulic
unit is switched on.
• The remote control display shows "SELECT FUSE". The
last alternative used is preset. Choose another gear using
the arrow keys. Press OK to confirm the selection.
With a 25 A fuse you can use approx. 70% of the full
output. With 16 A you can use approx. 50% of full output.
The function is intended to obtain as high output as
possible without overloading the fuse.
• The remote control display shows "SELECT GEAR". The
last alternative used is preset. Choose another gear using
the arrow keys. Press OK to confirm the selection.
On gear 1, the speed range is 600-900 rpm and on gear
2 the speed range is 800-1200 rpm. Check that the
mechanical gear on the saw unit is corresponding with the
electrically set gear in the remote control.
• The display now shows "HUSQVARNA PP-480 HF
PRESS START".

Operations menu

As long as the power unit has voltage but the blade rotation
stands still, the display shows "Husqvarna PP-480 HF
PRESS START".
Before starting, all controls must be turned to zero position. If
this is not done, a message in the display will prompt this
when the start button is pushed. "TURN OFF TRAVEL
FEEDING" or "TURN OFF DEPTH FEEDING" or "TURN OFF
BLADE".
When the blade rotation is started, the display shows "X RPM,
Y%, Z A", where X equals the engine speed, Y equals the
output percentage of the maximum effect, and Z equals the
selected fuse.
By navigating with the arrow keys, the following settings can
be reached:
• Water coolant
• Select language
• Id power unit
• Time
• Total machine time
• Rotation direction
• Battery status
Water coolant
Select mode AUTO or ON. If AUTO is selected the water
cooling is activated when the blade rotation starts. If ON is
selected the water valve is always open. The water can be
switched of manually with the water tap. The default mode at
startup is AUTO. Selected mode is shown in the display.
Change mode by pressing OK.
10 –
English

SETTINGS AND ADJUSTMENTS

Select language
Using this sub-menu you can set the language you wish to
use on the display.
Scroll using the arrow keys until the required language is
shown. Confirm with 'OK".
Id power unit
The display shows the identity number for the power unit.
Time
The function is used to measure the amount of time a job
takes. The time is counted from when the saw starts working.
Select:
• ON, to enable.
• OFF, to disable.
• RESET TIME, to reset.
Browse with the arrow keys and confirm with "OK".
Total machine time
Here the total operation time of the power unit is shown. The
time is shown in hours and minutes (hhhh:mm).
Rotation direction
Here you can set the rotation direction of the blade. Select
standard or backwards by pressing "OK".
Battery status
Here you can see the battery status of the remote control for
machines with radio communication.
• "NO BATT. CONNECT" - The machine does not have
radio communication.
• "CHARGING BATTERY" - The CAN cable is connected
and the battery is charging.
• "0% BATTERY 100%" - The bar shows the battery status.
• "BATTERY FULL" - The battery is fully charged.