Dometic S17G Bedienungsanleitung Seite 30

Troubleshooting
Problem
The light does not work.
The appliance vibrates
The appliance seems to
make a lot of noise
The door does not close
properly
LED indicates E1, E2 or E7.
30
Possible cause
Appliance is not connected to a
power supply
Circuit breaker or fuse has blown Switch on circuit breaker or
The light was switched off on the
control panel.
The appliance is not properly
level
The noise is probably caused by the refrigerant, which is
normal. At the end of each cycle, you will hear noises made by
the flow of refrigerant.
If temperature fluctuations occur, the contraction and expansion
of the inner walls may cause popping and cracking noises.
The appliance is not properly
level
The appliance is not properly
level
The door hinge was changed
incorrectly
The door seal is dirty
The shelves are not fitted cor-
rectly
The temperature sensor for the
fan inside the appliance shows
an error
MaCave
Remedy
Connect the appliance
replace fuse
Switch on the light
Level the appliance with the
adjustable feet
Level the appliance with the
adjustable feet
Level the appliance with the
adjustable feet
Check the door hinge and
reassemble correctly
Clean the door seal
Check the shelves and refit
correctly
This can only be repaired by
an authorised repair centre.
EN