Panasonic EY7881 Bedienungsanleitung Seite 14

Variable speed control trigger
EN
To set the center of a hole, pull the trigger
slightly to start the drill rotation slowly.
Support handle [Fig.7]
Place the support handle at your favorite
position and tighten the handle securely.
CAUTION:
Always make sure to tighten the handle
securely before use as illustrated
below, to avoid injurt.
Depth gauge [Fig.8]
Loosen the support handle and adjust the
depth gauge at your favorite depth.
After adjusting, tighten the support handle
and fix depth gauge.
Control panel
(G) LED light [Fig.9]
Before the use of LED light, always pull
the power switch once.
Press the LED light on button.
The light illuminates with very low current,
and it does not adversely affect the perfor-
mance of the tool during use or its battery
capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tempo-
rarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
(I) Battery Level Indicator
Press the battery level button.
Battery level indicator shows battery level
in three levels while pressing the button.
NOTE:
The indicator will not show the battery
level when the button is pressed in the
following cases.
• The tool is powered off.
• Just after attaching the battery pack
• The main unit or battery level button is
not operated for approx. five minutes.
Press the battery level button again
after depressing the trigger switch.
• If the battery temperature is high, stop
the operation and wait until the battery
temperature is low.
Indicator
3 lamps
illuminated
2 lamps
illuminated
One lamp
illuminated
3 lamps
flashing
This battery level function is only a guide
and indication may change due to the
condition of the battery or ambient
temperature.
Excessive (complete) discharging of
lithium ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
Warning Functions
(1) Overheat Warning
Off
(normal
operation)
- 14 -
Battery status
Fully charged
or high charge
level
Approx. 60%
remaining
Low level
- Will require
charging soon
Empty
- Immediate
charging
required
Illuminated: Flashing:
Overheat Overheat
(motor) (battery)