Werbung
Verfügbare Sprachen
Verfügbare Sprachen
activate your source device. In standby, press the remote's alarm key to toggle the
EN
alarms on or off without having to go into the Menu.
To Snooze, press the Menu knob or the Snooze key on the remote. Snooze will re-set
each time it is pressed.
To stop the alarm, press Amico's power button or the Alarm button on the remote.
Note: If Amico is Off and the external adapter is not connected, the alarm cannot
activate.
Sleep:
To set the Sleep timer, press and hold the Menu knob, rotate to "Main menu" and select
it by pressing in the Menu knob, then rotate to and select "Sleep". Rotate the Menu
knob to scroll through the sleep time options and select a Sleep period by briefly
pushing in the Menu knob. The display will eventually time out to the "Now playing"
screen and the Sleep icon and time will be displayed at the bottom of the display.
Note: If Amico is Off and the external adapter is not connected, Sleep cannot operate.
Daylight Savings Time adjustment/Clock accuracy:
If the time is incorrect by 1 hour, go into the System settings menu > Time/Date > Adjust
to DST > and select +1 or -1 hour to correct the time. While in System settings, verify
"Auto update" under Time/Date is set to "Update from network" and that you have a
consistent WiFi signal, as loss of signal will reset the time to twelve o'clock until the WiFi
signal is restored.
Bluetooth:
Rotate the source knob to Bluetooth and push in briefly to select. Open Bluetooth on
your enabled device and search/scan for the "Como Amico" name, then pair and
connect. Once you've paired you shouldn't need to do it again. If your device prompts
you to enter a passcode, enter "0000". Set your smart device's volume at 100% and
adjust Amico's volume as needed. If you use other Apps for music streaming, you can
connect your smart device via Bluetooth to stream them to Amico.
Backlight (in Menu > System settings > Backlight):
The On Level affects the backlight level whenever the unit is on.
The Dim Level affects the backlight level whenever the unit is in standby. You must
select a Timeout value in the Backlight menu in addition to the Dim Level in order for
the Dim Level to take effect in standby.
7
Werbung
