COMO AUDIO AMICO Bedienungsanleitung Seite 3

Push in twice in standby (when the power supply is conncted) to turn the display off,
and twice again to turn the display back on.
4. Presets: Press and hold to save a tuned station or a source. Push in briefly to recall
the saved station or source. The presets are independent and are not restricted to
whichever source is playing. The presets will also turn Amico on from standby (when
the power supply is connected) if a station or source has been saved to that preset.
Carefully selected Internet stations have been saved to each preset.
5. NFC (Top of cabinet):
If your Android smart phone has NFC, make sure it is switched on in your device and be
sure the display on your device is unlocked. Change Amico's source to Bluetooth. When
the Bluetooth icon begins flashing after about 15 seconds in the lower right corner of
the display, touch the NFC area of your smart phone to the NFC logo on the top of
Amico's cabinet. You may need to adjust your smart phone's position around the
cabinet's NFC logo until it locates the signal. If your smart phone is in a case, the case
might reduce the NFC signal. Once NFC is established, follow the instructions displayed
on your smart phone's display to establish the Bluetooth connection. Touch your smart
phone to the cabinet's NFC logo again to disconnect from Bluetooth. If your device does
not support NFC, see the section marked "Bluetooth". You should not need to pair or
use NFC again after successfully pairing a device, except to disconnect from Bluetooth.
You can peel off the NFC sticker if you prefer.
3
EN