Herunterladen Diese Seite drucken

Installation - Massoth DiMAX Handbuch

Funksender
Vorschau ausblenden Andere Handbücher für DiMAX:

Werbung

1. Einleitende Information
Der DiMAX Funksender erweitert den
DiMAX Navigator zum Funkhandregler.
Der mit externer Drahtantenne ausge-
stattete Funksender gestattet bidirekti-
onalen Freilandbetrieb bei Reichweiten
bis ca. 100 Meter. Innerhalb und
zwischen Gebäuden können Reichweiten
von bis zu 100 Meter erreicht werden.
Der Navigator benötigt einen Firmware-
stand von mindestens Version 1.2. Für
den Betrieb wird der DiMAX Funkemp-
fänger (Art.-Nr.: 8133001) benötigt.
1.1. Funktionsumfang
• Bidirektionaler FM Funksender
• 433 MHz Frequenzband
• 4 wählbare Kanäle.
• Reichweitenoptimierung durch intelli-
gente Fehlererkennung und -korrektur.
1.2. Lieferumfang
• Funksender mit Kabelantenne
• Bedienungsanleitung
2. Einbau
Lösen Sie die 5 Schrauben wie in Abb.
1 gezeigt. Nachdem Sie die Rückseite
des Gehäuses abgenommen haben,
sehen Sie die Hauptplatine (Abb. 2),
die Buchse für das Buskabel sowie
das Display. Rechts unterhalb des
Displays befindet sich der Sockel mit 10
Stiften zur Aufnahme des Funkmoduls.
2
1. General Information
The DiMAX RC Sender extends the
DiMAX Navigator with radio control. The
technology allows bidirectional outdoor
use with ranges of appr. 320 feet. Even
inside and between buildings a radio
range of 320 feet can be reached. The
Navigator requires a minimum firmware
of version 1.2. If required please per-
form a firmwareupdate. The DiMAX RC
Receiver (Art.-No.: 8133001) is required
for radio control operation.
1.1. Summary of Functions
• Bidirectional FM RC sender
• 915 MHz wave band
• 4 selectable channels
• Operating distance optimizing through
intelligent error detection and -cor-
rection
1.2. Scope of Supply
• RC Sender with cable antenna
• Manual

2. Installation

Release the 5 screws as shown in Il-
lustr. #1. After taking of the back cover
of the casing you can see the main
circuit board (Illustr. #2), the connector
for cable use and the display. The con-
nector for the RC sender is located on
the right side directly below the display.
Connect the RC sender with this con-

Werbung

loading