Installation And Removal Of Your Pcrn; Installation; Fine Adjustment Of The Installation Depth; Removal - Porsche Classic Einbauanleitung

Installation and removal
of your PCRN

Installation

1. Before getting started, ensure that the bat-
tery is fully disconnected from the onboard
power supply.
2. Remove the installation frame from the radio
device. If this is engaged, use the unlocking
keys supplied to release the frame.
3. Remove the old device, including installation
frame.
4. Check whether the new installation frame
can be correctly inserted in the DIN slot. The
installation frame is designed for installation
slots with dimensions of 183 x 52 mm (width
x height). Do not insert the installation frame
using force.
5. Bend the fastening tabs of the installation
frame upwards to ensure that the radio de-
vice is held reliably and firmly in the vehicle.
6. Position the radio device in front of the instal-
lation slot. Pull the connecting cables through
the installation frame and connect the cables
to the device. Carefully the connection dia-
gram and ensure that all cables are correctly
insulated.
7. We recommend mounting of the supplied
spacer on the rear of the device. The
spacer protects the radio connections and is
screwed into the thread provided. Then attach
the supplied rubber cap.
8. Push the radio device into the installation slot
until it engages in the installation frame.
9. Once the radio device is correctly cabled,
re-connect the battery. Turn on the radio device
with the ignition on and check whether the radio
device can be switched on. If this is not the case,
check the cabling once again. If the device still
cannot be switched on, please contact your
Porsche Centre.
Porsche 911 (to year of manufacture
1973):
With this vehicle model, adjustments are to
be made to the radio slot, since the supplied
1xDIN installation frame cannot be installed
without modifying the radio slot in the dash-
board. If you have any questions, please
contact your Porsche Centre.
Damage to radio device: Improper connection
can cause irreparable damage to the radio
device or the vehicle electronics.
Fine adjustment of the installation
depth
To adjust the installation depth to the vehicle
model concerned, loosen the screws of the
adjustment device on both sides of the device.
Adjust the position accordingly and then re-tighten
the screws.

Removal

1. Insert the two supplied unlocking keys into
the openings provided on the left and right
at the edge of the device front, until they
engage.
2. Carefully pull the device forward out of the
radio slot using the two unlocking keys.
3. Disconnect all plugs from the rear of the
device.
4. Remove the installation frame from the radio
slot.
Installation instructions