Setup - Tesla Series 3 Betriebsanleitungen

ATV Manual Tuning
In ATV mode, select ATV Manual Tuning and press OK button to access.
1. Use direction buttons to highlight and set up Storage To 1 (maybe other number), Color
System, Sound System and Current Channel. Then select search and press  or  to start
the search.
• Press  for the unit to search towards higher frequency;
• Press  for the unit to search towards lower frequency;
2. When a program is found, press the red button to stored it at the current channel position.
If you want to stop the search, press MENU button.
• Fine-Tune
Use to make small adjustments to tuning of an individual channel. Fine-tune is not
necessary under normal conditions. However, in area of inferior broadcast conditions
where adjustments is necessary for a better picture and sound, use fine-tune.
1. Select a channel that you want to fine tune.
2. In Installation menu, select ATV Manual Tuning and press  to highlight Fine-Tune.
3. Press  or  to fine tune until the best possible picture and sound are obtained.

Setup

OSD Language: Select your desired OSD language.
Audio Language: Set the primary or secondary digital audio language corresponding
to the signal.
Subtitle Language: Select the subtitle language.
Hearing Impaired: This feature is helping hearing-impaired users to understand the
programs by showing the relevant graphic information (similar to subtitle but not subtitle)
on the screen. You need to turn on the switch before using this feature.
Teletext Language: Select the teletext language as your desire.
REC File System: If you want to use this function, you must receive a digital program and
plug a USB disk.
Note:
Suggest to use a high speed mobile hard disk, or your TV may get stuck when using
the REC and time shift function.
HDMI CEC: Link and control both the TV and its external devices by connecting the
external device to the HDMI port of the TV.
HDMI CEC - Turn on or off HDMI CEC function.
Auto Standby - Turn the TV to standby automatically.
Device List - When HDMI CEC is on, you check the device list of connecting to the TV.
Location: Select the location mode of playing at home or at store, when select "Store",
you can turn on the sticker demo.
Presentation: Turn on or turn off the sticker demo and USB demo.
USB demo:
1. Required settings: Add "AutoDemo.txt" txt file at the root directory of a USB device,and
then write the route of videos need to be played on the TV, each route needs a line break.
2. When "USB Demo" is set up as "On", the TV will automatically play the videos in the
"AutoDemo.txt", after played all videos, TV will go back to play the previous watching
program. After five mintues, the TV will cycle playing wrote videos and program.
3. The route should be wrote in English or numbers, otherwise the TV can't identify it.
21
ENG