Channel - Tesla Series 3 Betriebsanleitungen

ENG

Channel

Auto Tuning
Select DVB-T or DVB-C and press ENTER button to go to the next step. Select country or scan
type and then search and store programmes automatically. If you want to stop the auto search,
press MENU button or EXIT button and exit dialog box will pop out.
• Press  to confirm exit.
• Press  to continue searching.
Advanced Tuning
Access the satellite settings essential for programme searching through DVB-S source.
Satellite Dish Settings (Step 1-3, refer to Fig. 1)
Before performing a channel scan configure satellite dish settings for each desired satellite.
Satellite - Select the satellite for this TV.
LNB Type - Make sure the LNB type is appropriate for your dish.
LNB Power - Enable or disable power supply for the LNB.
22KHz - Select the 22KHz to set 22K switch to ON/OFF. Use auto mode to switch 22KHz
on or off depending on the LNB type.
DiSEqC1.0/1.1 - Select the DiSEqC mode for the selected LNB.
Step 1
Step 1: Highlight Satellite and press ENTER to access the satellite list and select the desired
one.
Step 2: Highlight LNB Type and press ENTER to select the LNB type.
Step 3: Make sure that 22KHz, DiSEqC1.0/1.1 switch corresponds to the selected satellite.
After completing the above steps, press the blue button to search for the channels.
DTV Manual Tuning
Search and store programmes manually.
Channel DTV Manual Tuning
Select the source type (DVB-T or DVB-C) and search digital programmes manually. In the
Channel menu, select DTV Manual Tuning and press ENTER button to access.
Fig. 1
18
Step 2
Step 3