COGES BTDataKey Gebrauchsanweisungen Seite 14

item) and the format of recording to be executed among those available in 10.6
Recording Type menu item (refer to the manual of the System which can be
downloaded from the website: www.coges.eu at page Technical Support\Down-
load\Technical Manuals).
The combinations allowed for the recording via CL are:
• E.C.S. Standard (partial or cumulative totals);
• Change Giver (partial or cumulative totals);
• Full (partial or cumulative totals).
In the Contactless Mode (CL), the BTDataKey
shall be inserted in the proper Coges Reader.
The System compares its Operator Code and
that of the Key before sending the recording.
In the CL mode only the partial or the cumula-
tive totals can be recorded.
To extract the data in CL mode, follow the pro-
cedure reported on the table:
1. Insert the BTDataKey in the Reader's slot; wait for the key
switching on. The green LED flashes.
2. Connect to the Key via BLE by using the app of the smartphone or
switch on the palmtop terminal. The LED is fixed blue.
3. Start the contactless (CL) data recording from the app (via BLE)
or from the palmtop terminal (via IR). The LED is fixed green.
4. The data have been transferred from the System to the BTData-
Key: now they are transferred to the control device via BLE (blue
LED) or IR port (green LED). The pending data are signalled by 3
fast flashes and a pause.
5. At the end of the operation, if everything was successful the data
present in the BTDataKey are deleted. Disconnect the app. The
green LED flashes for some seconds.
6. Remove the BTDataKey and disconnect the BLE in the recording
from smartphone. The LED becomes fixed red before switching
off. Now the data result to be in the memory of the control
device.
14 GB BTDataKey
Function
DL1