US Blaster USB 7392 Benutzerhandbuch Seite 9

USB 7392 - 7393
Microphone systems
HANDHELD TRANSMITTER
1. Powerswitch:
To turn on press and hold the power button located on the bottom cap of the transmitter for 2-3 seconds,
until the LCD screen's light is on. To turn off press and hold the power button until LCD screen's light is off.
2. Built-in Transmitter antenna
3. Condenser and grille
4. Battery Cover: Insert 2 AA batteries into the battery slot, putting battery's polarity on different ends
may damage system and your warranty may be terminated if damage does occur because of it.
5. Battery power indicator light: If this light is flashing it means the battery power is low and must
be replaced.
6. up and down buttons: Adjustment buttons to change system statuses.
7. Set button: Opens the different statuses your system lets you adjust, and confirms adjustments.
NOTE: After using set and the up and down buttons to adjust your receiver's status, press set again to
confirm, or your adjustments will remain the same.
© US Blaster Europe BV